Kenwood KR-A5060 Instruction Manual page 9

SPEAKER SYSTEM A
While pressing lever (holding it).
EK Seeeeketetet
'atetoretate 25050605
reteteteta® O55
a teterete: oretererent
Petaterete® rasetetete'
rerere ere. EK
tate 06050505
'arateretate: Setatetetes
RS atetete
"agagececene secececenes!
'statetatere a rareteret
sotetetere' aretotecate'
aearetetece: eran aretet
aretecetece: sefetaterets
OG e0Fa FI9G.9.%,
(2) Insert cord.
(3) Release.
'ete%e"e7e" "ote" eres
B62 S555 an 5552 4
e Never short-circuit the + and - speaker cords. Selstetetse MN otetetorete
. : . Merererere, Seterateret
e lf the left and right speakers are connected inversely or if the seeseeeetes seetceetsest
speaker cords are connected with reversed polarity, the sound serecoreeee seesesesess
becomes unnaiural with ambigous acoustic image positioning. statetetete Seatetanet
0,4, %,0,%.% L@,0, 0,044
'aetetetets Satetetetet
Be sure to connect the speakers and speaker cords correctly.
SPEAKER SYSTEM B
Speaker IMPEDANCE SELECTOR cauTION : During operation of the speaker IMPEDANCE SELECTOR, set the POWER switch to OFF.
Set the IMPEDANCE SELECTOR switch on the rear panel according to the impedance of the front speakers used.
Front speaker impedance Selector position.
IMPEDANCE
SELECTOR
A or B speakers 42 ~ 6Q a
A BOR
Sgn NS Mone
IMPEDANCE
A or B speakers 8Q ~ 169
SELECTOR
A and 8 speakers 8Q - 162
LESS THAN, 820R
82 * MORE
.
@ itis not possible to use both A and B speaker systems if speakers have impedances from 4 ohms to 6 ohms.
' 1 fi
SLI:
—~ '@ a SEC FSS TRA "Fee ee B° 1° HRT EP Re eM ree fg eee RU ha