Kenwood KR-A5060 Instruction Manual page 21

case of aifticulty
Remote control unit
Remote contro! operation is not possible.
Amplifier
Sound is not output.
Soundis not output from one of the speak-
ers.
A hum noise is generated when PHONO
input selector key is pressed.
Tuner
Radio stations cannot be received.
Interference.
A station which was preset cannot be re-
ceived by pressing the corresponding nu-
meric key.
Speaker protection circuitry
e Batteries are exhausted.
@ The audio cords and system control cords are
not connected properly.
e The remote control unit is too far away from
the main system, controlling angle is too
large, or there is.an obstacle in between.
@ The source component to be operated does
not contain the tape(s) or CD.
e An attempt is made to play a tape which is
being recorded in the cassette deck.
@ The speaker cords are disconnected.
e The VOLUME is set to the minimum position.
e@ The SPEAKERS switches are set to OFF.
e@ The TAPE 2 key is set to ON.
@ The speaker cord is disconnected.
@ The BALANCE control is set to an extreme
position.
@ The audio cord from the turntable is not in-
serted securely into the PHONO jacks,
a The turntable ts not grounded.
@ No antenna is connected.
@ The broadcast band is not set properly.
@ The frequency of the desired station is not
tuned
e Noise due to ignition noise of an automobile.
e@ Noise cue to an influence from an electric
appliance.
@ Noise due to a nearby TV set.
e@ The preset station belongs to a frequency
that cannot be received, .
@ The preset memory was cleared because the
power cord had been unplugged for a long
period of time.
e Replace with new batteries.
e Connect properly referring to "System
connection". ~ [Pra]
e Operate the remote control unit within the
controllable range.
@ Place the tape(s) or CD in the source com-
ponent to be played.
e Wait uniil the recording is completed.
e Connect them properly referring to "Sys-
tem connection".
e Adjust the volume to a proper level.
@ Set the SPEAKERS switch(es} to ON.
e Set the TAPE 2 key to OFF.
e@ Connect it properly referring "System con-
nection".
@ Adjust the Left/Right balance.
@ Insert the audio cord plugs securely into
the PHONO jacks.
@ Connect the grounding wire to the GND
terminal on the rear panei.
@ Connect an antenna.
@ Set the broadcast band properly.
@ Tune the frequency of the desired station.
"£3
@ Install the outdoor antenna apart from the
road.
e Turn off the power of the appliance.
@ Install the system more apart from the TV set.
@ Preset a station with a receivable fre-
quency.
e Preset the station again.
If the speaker cords are short-circuited, the speaker protection circuitry is activated and the sound is muted. If this occurs, switch the POWER
key to OFF, remove the short-circuit from the speaker cords, and switch the POWER key to ON again. Normale operation will resume.
Ny
ge
1, This system is microprocessor-controlled, so malfunction may occur due to external noise or interference noise. In such a case,
unplug the power cord, plug it and turn power on again. -
2. Do not use contact cleaners because It could cause a malfunticon. Be specially careful against contact cleaners containing oil, for they
may deform the plastic components.