Zanussi MW530D Instructions Manual page 5

Installation
Electrical connections
To install your oven follow these three
steps:
1) Remove all materials from the oven
interior.
2) Place the oven in a location of your
choice. Make certain that the oven is on
a level surface and that there is at least
one inch {2.5 cm) of clearance at the top,
2 inch (5 cm) at the back and a total of
6 inches (15 cm) side clearance to ensure
proper ventilation. Note: Do not store
cookbooks or this instruction manual
inside or underneath the oven.
3) Make the electrical connection as
detailed below.
Electrical connection
Connection must be carried out by
Qualified personnel in accordance with
existing rules and regulations, making
sure that the electric network has an
efficient earth connection.
These appliances feature a three-pole
electric supply cable, having a plug with
fuse, and are designed to operate on
alternative current, with a single phase
voltage of 240V-50Hz.
This Zanussi microwave oven is fitted
with a moulded-on 13 amp plug, ready to
be plugged straight into an ordinary
13 amp power socket The only maintenance
required is if the fuse needs replacing.
To replace, use a 13 amp BS 1362 fuse.
Only ASTA approved fuses should be
used.
If the fuse blows you can replace it in
the following way:
Remove the plugs from the power socket
and use a small screwdriver to lever out
the red plastic fuse carrier located
between the plug prongs together with
the fuse.
Remove the old fuse and replace it with
a new 13 amp ASTA approved fuse and
clip the carrier back into the plug. The
fuse cover/carrier must be replaced in
the event of changing the fuse. The
correct fuse cover-carrier colour is the
one shown by the coloured insert at the
base of the prong face of the plug. The
plug must not be used if the fuse
cover/ carrier is lost. A replacement
cover/carrier can be obtained from your
local Zanussi Service Network addresses
of which are listed in the enclosed
Zanussi Service and Spares Nationwide
leaflet.
If the plug is not suitable it must be cut
off and the appropriate plug fitted.
The cut off plug should be disposed of to
prevent the hazard of electric shocks in
case it should be plugged into a 13 amp
socket in another part of the house. The
flex wires are colour coded as follows:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
Make sure you connect each wire to the
correct terminal inside the plug. The
plug's terminals may be colour-coded in
the same way as the wires. If not, the
earth terminal will either be coloured
green, green/yellow or be marked with
the letter "E" or be marked with the
symbol ©. The neutral terminal will
either be coloured black, or be marked
with the letter "N". The live terminal will
either be coloured red, or be marked
with the letter "L".
5