Advertisement
Quick Kleen® Fan Chamber
(On some models)
NOTE: Turn off the switch and unplug the electrical cord before cleaning.
The clear, removable fan chamber cover provides
easy inspection, cleaning, and maintenance of the
fan chamber. Removing the cover provides easy
access to the motor fan. Grease buildup, dirt, or other
obstructions, visible through the fan cover, should be
removed. To clean the fan area, take off the chrome
bottom plate by releasing the two cam locks (see
Brush Roll Belt, Figure 1 and 2). Remove the belt
from, the motor pulley, then loosen and remove the
screws on either side of the fan cover, as indicated
by the arrows. Push the cam locks outward against
the wheels to lift the cover from the cleaner base.
Dirt and obstructions can easily be cleared; however,
caked grease may need to be scraped from the
cover and the cleaner. If the fan does not turn freely,
it also should be removed for cleaning. To remove
the fan, place a wrench over the motor pulley. Hold the fan blades with one hand and
turn the wrench counterclockwise. Remove the motor pulley and lift the fan off the motor
shaft. Clean the area and replace the fan over the motor shaft. Tighten the motor pulley
snugly clockwise with the wrench. If necessary, replace the fan cover or the gasket with
replacement parts.
Be sure the gasket is in place. Reposition the fan cover by first placing the exhaust end
into place between the large rear wheels. Seat fan cover firmly. Next replace the belt and
bottom plate as the pressure from the bottom plate helps seal the fan cover. Start the two
screws by hand to be sure they are straight, then tighten.
Cleaner Care
NOTE: Turn off the switch and unplug the electrical cord before cleaning unit.
To keep the vacuum cleaner looking new, it can be wiped with a damp cloth and a mild soap
solution, then thoroughly dried. Never use any type of chemical as chemicals can damage
the cleaner. When not in use, the cleaner should be stored in a clean, dry place.
11
Advertisement
