Featurebox Update Via Usb Stick - Ten-Haaft OYSTER 60 Instructions For Use Manual

3. SERVICE

3.5 FeatureBox update via USB stick

Further to automatic updates via the app, which is the preferred option, updates can also be performed manually
using a USB stick.
You will need a USB stick formatted as FAT/FAT32 with the file tenhaaft.uf loaded into its root directory (top
level).
The UF-file is available from our website.
The maximum file size is approx. 6 MB, so the USB stick's storage capacity is not relevant.
Procedure Description
Switch on the FeatureBox!
The image shows a FeatureBox that is switched off and in stand-
by mode (left LED illuminates red).
The FeatureBox shown is active (left LED illuminates green).
Plug the USB stick into the port marked "USB" on the rear face
of the FeatureBox. The USB stick will then flash to indicate read-
ing access, and both LEDs on the front face illuminate (left LED
in green, then changing to red, right LED in red or flashing red).
In this mode, the data are transmitted from the USB stick into
the internal update memory of the FeatureBox. Depending on
USB stick and file size, this procedure may take some time (< 2
min.) and must not be interrupted!
The right-hand red LED turns off when this step is completed.
You can then remove the USB stick from the FeatureBox.
An LED illuminating blue can be ignored!
26
3. SERVICE
BLUE LED
Once the data are saved in the internal update memory, they can be distributed to the hardware components
connected to the FeatureBox.
This may happen automatically. However, it is often not possible to update all components at once because the
FeatureBox does not know which state a component is in (e.g. because the antenna is not connected when the
update is performed).
This condition is neither unusual nor critical!
The LED illuminating blue indicates that an update can now be started by pressing the "i" button.
UPDATE SEQUENCE
The components connected to the FeatureBox are updated in a fixed sequence: At first the FeatureBox is updat-
ed, then the motor controller of the antenna, and then the control panel.
For safety reasons, the motor controller is only updated after it has been reliably identified and when the antenna
is folded in. This is why the antenna may retract if you press the "i" button while the LED illuminates blue.
Sequence Description
Device is switched off (standby)
--> Switch on the device
Device is switched on
--> Plug in the USB stick
Data are being transmitted or updated
--> Do not touch – wait!
After the right red LED has turned off permanently, you can remove the USB stick.
--> Press the "i" button
27