Command Unit Update Via Usb Stick - Ten-Haaft Oyster Premium 65 Instructions For Use Manual

3. SERVICE

3.6 Command Unit update via USB stick

In addition to the automatic update via app, i.e. the usual variant, there is also the option of a manual update
via USB stick.
A FAT/FAT32 formatted USB stick is required onto which the file tenhaaft.uf is copied into the root directory
(top level).
The UF file is available on the website https://ten-haaft.com/updates/.
The maximum size of the file is approximately 6 Mbyte, so the storage capacity of the USB stick does not play
a role.
Sequence
oder
18
Description
Switch on the Command Unit!
The picture shows a switched-off Command Unit in
standby mode (right LED is red).
In this picture, the box is active (right LED is green).
Insert the USB flash drive into the socket labelled
"USB" on the back of the box. The USB flash drive then
shows reading activity (flashes), and both LEDs on the
front now light up (green on the left, or later red, red,
or red flashing on the right).
In this state, the data of the flash drive is transferred
to the internal update memory. Depending on the flash
drive and the update volume, this may take a while (<
2 min) and must not be interrupted!
The right red LED goes off permanently when this step
is completed. After that, the USB stick can be discon-
nected from the Command Unit.
A possibly blue LED, which might be on, does not
interfere with this!
3. SERVICE
Sequence
oder
You can remove the USB flash drive after the right red LED is permanently OFF
Description
Is switched off (standby)
--> Switch on
Is switched on
--> Insert USB flash drive
Something is transmitted or updated
--> Keep your hand off and wait!
19