Table of Contents
Advertisement
1. OPERATING THE SYSTEM
1.2 Settings
These settings can be made at the control panel or via the app.
Settings
Satellite settings
Manual search
Manual transponder
Receiver control
DiSEqC allocation
6
Azimuth
Elevation
Skew option
Frequency
Polarisation
Symbol rate
FEC rate
Modulation rate
ONID
Active
Switch-on delay
Switch-off delay
Mode
Mode
Sat 1 (manual)
DiSEqC position
Satellite
Sat 2 (manual)
...
Sat 3 (manual)
...
Sat 4 (manual)
...
DiSEqC status
1. OPERATING THE SYSTEM
Left / right changes the azimuth (in increments of 1°)
Left / right changes the elevation (in increments of 1°)
Left / right changes the skew angle (in increments of 1°)
Frequency in MHz
High / low
Symbol rate
Selection from a list of applicable FEC rates
"QPSK", "QPSK-S2" or "8PSK"
Network ID
"Yes" or "No". The display shows "Manual mode" when a manual transponder is active.
"Off", "Automatic" or "OpenSleep" (LNB Off switches the system into sleep mode with the antenna remaining unfolded)
Delay until the next check of the LNB voltage for power-up (3–90 sec.)
Delay until the next check of the LNB voltage for power-down (1–30 sec.)
Four presets can be selected: "ten Haaft" (default), "manual" (Sat 1 – 4 ), "NL Canal Digitaal" and "NL Joyne" (two Fastscan presets)
"Off" or 0 – 255 (position number of satellite)
Name of satellite to be shown for this position
... as with "Sat 1"
... as with "Sat 1"
... as with "Sat 1"
7
Advertisement
Table of Contents
