Set-Up; Operation - ETEKCITY EB4074C Series Manual

EN

Set-Up

The 2 AAA 1.5V batteries are preinstalled in the
scale battery compartment. Slide open the
battery compartment cover located on the
backside of the scale and remove the plastic film
from the batteries. Re-apply the batteries under
the correct polarity and re-seal the battery
compartment in order to activate the scale.
4

Operation

Weight Measurement
1. For best results, place the scale on a hard, flat
surfaces. Avoid carpet or soft surfaces.
2. Step on the scale, then step off. Wait for the
screen to display " 0.0 " before using.
3. Stand on the scale until the display flashes
several times, showing your final measurement.
NOTE: For accuracy, the digital scale may
trigger automatic calibration when physically
lifted and moved or when the unit of
measurement is changed. Should a 'C' appear
on the digital display at any time, wait for the
digital screen to display '0.0', then step on to
weigh with accuracy.
Converting Weight Units
To change the unit of measurement (kg, lb, or
1.
st), step on the scale to turn it on. Then, turn
the scale over and press the unit conversion
button on the underside.
The default unit is pounds (lb). After changing
2.
units, the scale will show the new unit of
measurement.
4
3
Battery Replacement
1. Slide open the battery compartment cover
on the backside of the scale.
2. Take out the used batteries and dispose them
properly.
3. Install 2 new AAA 1.5V batteries, taking note of
the correct polarity displayed within the battery
compartment.