Programming Devices - Softlog Systems ICP2-ISO Quick Start Manual

ICP2-ISO(G3) Quick Start
- press "Save"
•
Transfer Environment to Programmer
- open "Environment → Transfer Environment to Programmer", select your environment and
press "Open"
- wait until environment is transferred to all channels
•
Switch to Standalone Mode: press "Standalone Mode" TAB on the Control Center
•
Your system is ready for parallel programming
5.4

Programming Devices

•
Connect devices to be programmed
•
Press F5
•
Repeat steps above for more devices
Rev: Mar-2024 Page 4 of 6