Table of Contents
Advertisement
Installation of the Metal Platter to the unit
1. Turntable belt (pre-installed to the metal platter)
2. Ribbon (pre-installed to the turntable belt)
3. Pulley of the turntable
Steps:
A) To take the metal platter, which has pre-installed with the
turntable belt and ribbon, out from the box.
B) To follow the diagram to pull out the ribbon/turntable belt
and fasten it to the pulley of the turntable unit.
C) To remove the ribbon from the turntable belt before use.
Keep it for use in the future.
RELEASE THE TURNTABLE
Raise the lid to expose the turntable. The turntable has been
secured for shipment with a transit screw. Use a coin or
screwdriver to turn the transit screw clockwise. This will allow
the turntable to float and operate normally.
INSTALLATION OF COUNTER WEIGHT
1.
SLIDE IN THE COUNTER WEIGHT COMPLETELY INTO THE REAR OF THE TONE ARM UNTIL IT REACH THE
END，TURN IT CLOCKWISE UNTIL IT CLICK WITH PIT INSIDE.
2.
TWIST THE COUNTER WEIGHT CLOCKWISE & BACKWARD UNTIL IT REACH THE WHITE LINE AS FIGURE 2
TWIST THE COUNTER MARKING UNTIL IT REACH " 1 " POSITION
3.
4.
TWIST THE COUNTER WEIGHT ANTI-CLOCKWISE & INWARD UNTIL IT REACH THE APPROPIATE WORKING
PRESSURE.
REMARK : THE WORKING PRESSURE OF THE PROVIDED STYLUS IS FROM THE RANGE 4 – 6 GRAMS
ACCORDING TO THE CARTRIDGE MANUFACTURER. ALL STYLUS HAS IT OWN WORKING PRESSUE
AND PLEASE REFER TO THE SPECIFICATION RESPECTIVELY.
CONNECTION
1.
CAREFULLY REMOVE THE UNIT FROM THE CARTON AND REMOVE ALL PACKING MATERIAL FROM THE UNIT.
2.
TAKE OUT THE AC/DC ADAPTOR (33) AND UNWIND THE CABLE AND EXTEND IT TO ITS FULL LENGTH.
3.
CONNECT THE SPEAKER CABLES TO THE SPEAKER TERMINALS (34)
4.
INSERT THE DC PLUG (34) TO THE DC JACK (23) OF THE MAIN UNIT, THEN CONNECT THE AC/DC ADAPTOR
(33) TO AC OUTLET
5.
PRESS THE POWER BUTTON AND THE LCD DISPLAY (7) WILL LIGHT UP. IT MEANS THE POWER SUPPLY IS
NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
TRANSIT SCREW
5
Advertisement
Table of Contents
