Electrolux RCB 24 P Maintenance And Repair Manual page 6

6 | UNPACKING
After unpacking the appliance, first make sure it has not been damaged in transit.
If any damage has been incurred, please inform the responsible supplier immediately and submit the deli-
very note or proof of purchase.
UNDER NO CIRCUMSTANCES MAY A DAMAGED APPLIANCE BE PUT INTO OPERATION.
Most of the packaging can be recycled and should therefore be taken to the area recycling centre. Please
remember that, with regard to environmental protection, the remaining materials should be disposed of in a
proper and orderly manner.
KA | CLEANING
Before putting into operation, the interior and exterior should always be cleaned :
e Add some mild detergent to lukewarm water
e Clean the interior and exterior of the appliance with a damp cloth.
e Dry the cleaned parts thoroughly; never use any kind of heater for this purpose.
NEVER USE ACIDIC OR CAUSTIC DETERGENTS, SCOURING POWDER,
STEEL WOOL, ABRASIVE SPONGES, CHEMICAL SOLVENTS
OR POLISHES TO CLEAN THE APPLIANCE.
Once the appliance has been put into operation, clean the container, lid and storage baskets regularly.
Remove any dust and dirt from the covers inside and outside the appliance, and from underneath the covers
several times a year with a brush or a vacuum cleaner.
8 | | INSTALLATION
In order to ensure perfect operation, please observe the following :
Install the appliance in a dry, well ventilated room.
Make sure the appliance is positioned firmly and securely.
There should be a distance of approximately 10 cm from any walls or adjacent appliances.
Do not expose the appliance to direct sunlight or operate it in the immediate vicinity of other sources of
heat.
Make sure that air can circulate freely through the vents and that these remain unobstructed at all times.
No objects or liquids should be allowed to enter the appliance through the vents.
The THERMOSTABILIZER is splash-proof. When using outdoors however, the appliance should be protec-
ted against sand, snow and heavy rain.