Solight DT34 Instruction Manual

EN DT34
Timer with dusk sensor
Thank you for purchasing our dusk sensor timer. Please read this manual carefully and pay attention to the safety warnings and
instructions before using the device. This will ensure not only the protection of persons but also the long term viability of the device.
TECHNICAL PARAMETERS
Input/output voltage
Maximum output current
Maximum load
Degree of coverage
Operating temperature
Number of operating modes
To activate the dusk sensor
To deactivate the dusk sensor
DESCRIPTION OF EQUIPMENT
CONTROL AND START-UP
Connect the device to the mains and the power LED will light up when connected.
Turn the knob to select the desired programme.
Programs:
OFF - switching off the device
ON - switching on the device (without dimming sensor)
DUSK/DAWN - switching on the device from dusk to dawn, activation by the dusk sensor ( < 5-15lx.)
2 hrs - switching on the device for 2 hours, from the activation of the twilight sensor
4 hrs - switching on the device for 4 hours, from the activation of the twilight sensor
6 hrs - switching on the device for 6 hours, from the activation of the twilight sensor
8 hrs - switching on the device for 8 hours, from the activation of the twilight sensor
- To ensure proper operation, do not cover the dusk sensor or place it within the range of artificial light.
- Switching on the lighting (for more than 8 seconds and with light intensity > 30-70 lux) switches off the dusk sensor and the selected
program. When the lighting is switched off, the program restarts.
230V
16A
3600W
IP44
-10°C to 40°C
6 (ON / twilight sensor / 2 h / 4 h / 6 h / 8 h)
<5-15lux
<30-70lux
① –
LED power indicator
② –
Twilight sensor
③-⑨ –
Programmes
⑩ –
Selected program indicator