Advertisement
6.
MAINTENANCE
WARNING! Disconnect from mains supply before performing any maintenance.
‰
6.1.
Remove the cut 'plug' from the cutter, each time it is used.
6.2.
Keep the tool clean.
6.3.
Store in a dry, childproof location in its case.
7.
TROUBLESHOOTING
PROBLEM
Magnetic base does
not function
The machine does not
work after powering
up.
The magnetic base
suction is weak.
The guide rail does not
run after turning the
handle.
Drill out the elliptical
hole.
Hard to shift gears.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
POSSIBLE CAUSE
The contact of the switch is poor.
The power supply is broken.
The circuit board is burned out.
The electromagnet is short-circuited or burned out.
Not adsorbed on the steel frame.
The magnetic disk has been used for a long time
and has been heated and leaked.
The contact of the switch is poor.
Connectors are loose.
Poor contact between brush and commutator.
The armature or stator coil of the electric drill is
burnt out.
The suction workpiece is too thin.
The adsorption surface is too small.
The support rod is not topped to the suction surface.
The diode may be pseudo-soldered.
The shaft key is broken.
The gear and rack are misaligned.
The pin on the lifting gear is broken.
The fasteners are loosened due to the vibration of
the machine.
Bit unilateral cutting.
There are impurities on the adsorption surface.
The machine must be turned off before changing gears. Turn the spindle with one hand and turn the shift
knob with the other.
sales@sealey.co.uk
Original Language Version
SOLUTION
Check/Repair the switch.
Check/Repair the power supply.
Replace the circuit board.
Repair or replace the disk.
Change the adsorption surface.
Repair or replace the magnetic disk.
Repair/Replace the switch.
Check the connectors.
Repair or replace the brush.
Replace the armature or stator.
Replace the adsorption surface or thicken the
adsorption surface (>10mm steel sheet).
Replace adsorption surface or temporarily weld thick
adsorption surface.
The magnetic base suction is weak.
Reweld the diode.
Replace the shaft key.
Loosen the screws under the rack and remove the
guide plate for repair.
Replace the pin.
The fasteners are loosened due to the vibration of
the machine.
Regrind the bit.
Eliminate impurities.
www.sealey.co.uk
MAG110VLP
Issue 2 (ALL)
17/07/23
Advertisement
