Kohler Stillness Smart Soak K-31404-PF-HW1 Homeowner's Manual page 6

Press the "Down" button once to decrease the temperature 1°F (0.56°C).
Press and hold the "Down" button to decrease the temperature 1°F (0.56°C) every 1/2 second, down to 86°F (30°C).
Filling the Bath
NOTE: The manufacturer default water temperature is 100°F (38°C).
NOTE: The maximum water level is approximately 8" (203 mm) below the rim. [Bath Full] will display on the remote
control if the "Fill" button is pressed while the water is at the maximum fill level.
NOTE: The "Fill" button will illuminate for 3 seconds unless another button is pressed within that timeframe.
Press the "Fill" button to begin filling the bath. Bath will automatically fill to the maximum water level.
Stop fill - Press the "Fill" button while water is entering the bath.
Draining the Bath
Open drain - Press the "Drain" button when the drain is closed to open the electronic drain.
Close drain -Press the "Drain" button when the drain is open to close the electronic drain.
1485077-5-B
6 Kohler Co.