AEG L7WBI864T4 User Manual page 36

2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start / Pause
programme again. The ProSense phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The ProSense detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced by means of the Time
Save button.
The ProSense Technology is not
available with all programmes such
as :Wool, Rinse and programmes with
short cycles.
11.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start / Pause
The related indicator flashes.
36 ENGLISH
is
button to start the
button.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Start / Pause
The washing programme continues.
11.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to activate
the appliance.
If the ProSense Technology has
completed and the water filling has
already started, the new programme
starts without repeating the ProSense
Technology. The water and the
detergent are not drained out in order to
avoid waste. The display shows the
maximum duration of the programme,
updating it about 20 minutes after the
starting of the new programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing programme.
11.11 Opening the door - Adding
garments
If the icon is on, you can always open the
door.
If the temperature and level of the water
in the drum are too high and/or the drum
is still rotating you should not open the
door.
While a programme or the delay start
operates, the appliance door is locked. The
display shows the indicator
1. Touch the Start / Pause
In the display the related door lock indicator
goes off.
button again.
.
button.