Paradyne 3800Plus Installation Instructions Manual page 7

3. Rotate the circuit pack lock(s) into the closed
position, and tighten the screw.
Circuit
Pack
Lock
Closed
(Locked)
Open
(Unlocked)
Latch
4. If the carrier is connected to power, the Power
LED on the faceplate of the 3811Plus lights up.
After several seconds the modem completes its
power-up self-test in which all faceplate LEDs
light up.
If the modem fails, or an alarm condition exists,
the Alrm LED on the faceplate lights up or
flashes. It may be possible to run a diagnostic
self-test from the SDCP. See Test Branch in the
COMSPHERE 3800Plus Modems User's Guide.
Return to the rear of the carrier and tighten the
rear connector plate.
5. Connect an RS-232D DTE cable to the top
connector of the rear connector plate. (The bottom
connector is unused.)
6. Connect the other end of the cable to your DTE.
3980-A2-GZ41-20
Check the SDCP
If an SDCP is installed, verify that the SDCP can be
used to control the modem. Perform the following steps.
SDU 1
Circuit
Select
Card
Key
Guides
1. Press the
2. Press the
3. Press the F1 ( ) or F2 ( ) key until the carrier
495-14813
4. Press the
5. Press the F1 ( ) or F2 ( ) key until the slot
6. Press the
7. Configure the modem as described in the
June 1998
Carrier Slots 1–16
2 3 4 5 6 7 8 9 10
Select
F1 F2
OK Alarm BckUp Test EC
Keypad
Status
Indicators
Procedure
key on the SDCP. The cursor
Select
appears in the two-digit slot selection entry.
key to position the cursor on the
two-digit carrier selection entry.
number you want appears on the LCD.
The carrier number selection has a range of 1 to 8.
With an SDU installed, a single SDCP can control
up to eight carriers.
key to position the cursor on the slot
selection entry.
number (1–16) you want appears on the LCD.
(Ignore the AB designator that appears on the
LCD since it is not applicable to the 3811Plus
modem.)
The Front Panel LED on the modem's faceplate
lights up.
key to place the SDCP in direct
Select
communication with the selected modem.
The LCD displays the Top-Level menu for the
selected modem.
following section, Select Factory Configuration
Options.
11 12 13 14 15 16
F3 COMSPHERE 3000
LCD
Display
496-12348a-03
7