Table of Contents
Advertisement
BATTERY POWER OPERATION
RECHARGEABLE BATTERY (OPTION)
1. Open the battery compartment lid as illustrated.
2. Insert the two pin polarized plug of the Battery Pack (Model
NTP-10, optional) into the BATTERY SOCKET of the set.
BATTERY SOCKET
3. Install the Battery Pack (Model NTP-10, optional) into the
compartment. It will fit firmly by the holder as illustrated.
4. Close the battery compartment lid.
NOTES: • The BATTERY CHARGE switch shoulcl be set to
the "OPERATE"position.
• A fui/y charged battery will operate the set for
approximately 3 hours.
• The need for recharging the Battery Pack will be
indicated when the picture shrinks in size and does
not fill the screen. Refer to BATTERY CHECK/NG
on page 4.
• Be sure to disconnect the AC or DC power cord
from the AC or DC POWER INPUT SOCKETS of
the set when using the set from the batteries.
Battery Recharging
When the need for battery recharging is indicated, follow the
steps below.
1. Connect the AC power cord to the AC outlet.
2. Set the BATTERY CHARGE switch to the "BATT CHARGE"
position. The CHARGING INDICATOR ® will be illu¬
minât ed.
The battery will be automatically charged.
NOTES: • A complété recharge will take approximately 20
hours.
• The battery may be recharged at any time by leasing
the setplugged in whilenot in use so that the battery
will a/ways be ful/y charged and ready for portable
operation.
Left side
t
OPERATE
3
Advertisement
Table of Contents
