Dexter Laundry 300SD2-23.5 Instructions Manual page 103

FR
2. SAFETY INSTRUCTIONS
ES
Drill safety wainings
PT
1) Safety instructions for all operation
a)Hold the power tool by insulated gripping surfaces.when performing
an operation where the cutting accessory or fasteners may contact
IT
hidden wiring or its own cord.Cutting accessory or fasteners contacting a
"live" wire may make exposed metal parts of the power too"live" and could
give the operator an electric shock.
EL
2) Safety instructions when using long drill bits
PL
a)Never operate at higher speed than the maximum speed rating of the
drill bit.At higher speeds,the bit is likely to bend if allowed to rotate freely
without contacting the workpiece,resulting in personal injury.
UA
b)Always start drilling at low speed and with the bit tip in contact with
the workpiece.At higher speeds,the bit is likely to bend if allowed to rotate
RO
freely without contacting the workpiece,resulting in personal injury.
c)Apply pressure only in direct line with the bit and do not apply
excessive pressure.Bits can bend causing breakage or loss of
EN
control,resulting in personal injury.
Even when the tool is used as prescribed it is not possible to eliminate
all residual risk factors. The following hazards may arise in connection
with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being
Intended use
This tool is intended to be used for drilling in wood and metal sheets, screwing.
Do not use machine for works other than those for which they are designed for!
All other applications are expressly ruled out.
Residual risks
used over longer period of time or not adequately managed and properly
maintained.
WARNING:
medical implants. To reduce the risk of serious injury, we recommand
persons with me dical manufacturer before operating this machine.
103