Table of Contents
Advertisement
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the speakers.
4. Remove the
3-cell battery
About this task
NOTE:
This procedure applies only to computers shipped with a smart card reader installed.
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Figure 46. Removing the smart card reader
Steps
1. Open the latch and disconnect the clickpad flexible flat cable from the connector (TFAD1) on the clickpad.
2. Remove the four screws (M2x2) that secure the smart card reader to the palm-rest and keyboard assembly.
3. Remove the smart card reader from the computer.
Installing the smart card reader
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
If the rubber grommets are pushed out when removing the left speaker, push them back in before replacing the left
speaker.
The following images indicate the location of the smart card reader and provide a visual representation of the installation
procedure.
Before working inside your
or the
4-cell
battery, whichever is applicable.
computer..
Removing and installing Field Replaceable Units (FRUs)
79
Advertisement
Table of Contents
