Cleaning Your Appliance - Blaze Outdoor Products BLZ-4LTE3NG Use & Care Manual

can be either opened or closed to make adjustments to the flame's appearance. To adjust, remove the burner
from the appliance and loosen the Philips head screw holding the air shutter to the burner. If the flame is yellow,
open the air shutter to make the flame bluer. If the flame is lifting off the burner surface, slightly close the air
shutter. Re-tighten the Philips head screw and re-install the burner to recheck the flame appearance. Repeat if
necessary. Turn burners to low flame setting and test for proper flame height. Flame should be stable and
burning out of each burner port without danger of going out in the lowest setting. (To adjust the LOW flame
setting simply light the appliance on the LOW setting and adjust the screw located under the knob on the front
of the valve using a flat head screwdriver as seen in the diagram below.)
NOTE: Always wait until your appliance is completely cool before cleaning. You should clean your appliance after each use to
maintain the overall appearance over the life of your appliance. After the first use, it is normal for your appliance to become
discolored in certain areas from the heat produced by the burners. A video for cleaning your grill is located on the blaze website
to assist with the below instructions,
Exterior Cleaning
When cleaning your appliance, always scrub and polish in the direction of the stainless steel grain. Wipe down the exterior of
the appliance to remove any splatter or grease. Do not use harsh abrasives. Use a stainless steel cleaner to clean the exterior
surface for a polished look. To remove baked-on foods, use a fine to medium grit non- metallic abrasive pad with a stainless
steel cleaner to avoid specks of grease collecting in the grain causing the appearance of rust. Before installing the cover, always
allow the surface to dry. DO NOT cover a damp appliance.

Cleaning Your Appliance

www.blazegrills.com
Blaze Instructional Book
Low flame setting
screw
.
Page | 30