Paradyne 3166 Quick Reference page 6

7. To daisy-chain the diagnostic channel with that of other 3166 DSU/CSUs or a T1
auxiliary backplane, insert one end of the short diagnostic channel extension cable
into either DIAGNOSTIC CHANNEL connector on the rear connector module.
Insert the other end into either DIAGNOSTIC CHANNEL connector of a
neighboring 3166 rear connector module, or the diagnostic channel connector of a
T1 auxiliary backplane.
DIAGNOSTIC
CHAN
PORT PORT
1
PORT
1
PORT PORT
2
PORT
2
SLOT 7 (15)
SLOT 6 (14)
SLT 8 (16)
DTE DTE
DTE
MODEL NO.
3100-F1-900
COMCODE
107170409
CAUTION:
The power-up self-test begins when power is applied. During the power-up self-test, the
Fail LED flashes, then all LEDs blink twice. When the test is complete, verify that the
DSU/CSU is functional by observing that the OK and NET Sig LEDs are lit.
The Factory 1 configuration for ESF framing format and B8ZS line coding format is the
default configuration and is appropriate for most networks. If this configuration does not
work for you, try the Factory 2 configuration for D4 framing format and AMI line coding
format. To further customize configuration options, refer to Changing Configuration
Options in Chapter 3, Operation , and Appendix C, Configuration Options , in the
ACCULINK 3166 DSU/CSU User's Guide .
CLOCK IN
PORT
1 1
PORT PORT
1 1
PORT
2 2
PORT PORT
2 2
SLOT 5 (13) SLOT 4 (12) SLOT 3 (11) SLOT 2 (10)
DTE DTE DTE
T1 NETWORK
INTERFACE
DISCONNECT ALL TELEPHONE LINES AT THE NETWORK
INTERFACE BEFORE TOUCHING OR SERVICING
Diagnostic Channel
Extension Cable
DIAGNOSTIC
CHAN
PORT
1
PORT
1
PORT
2
PORT
2
SLOT 1 (9)
DTE
DTE
4
NET NET
DIAGNOSTIC DIAGNOSTIC
CHANNEL CHANNEL
PORT 1 PORT 1
COM COM
98-16080