Table of Contents
Advertisement
Fault
The drying time is too
long.
Water is leaking from
the appliance.
Water overflows when
filling the water tank.
The laundry is too
damp.
Cause and troubleshooting
Clean the heat exchanger.
2.
→ "Cleaning the base unit", Page 37
→ "Closing the base unit", Page 38.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 14
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 30
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 38
The water tank for the crease-removal function is
empty.
→ "Filling the water tank", Page 33.
▶
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
The water tank filter is soiled.
→ "Cleaning the water tank filter", Page 38.
▶
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 24.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Troubleshooting en
43
Advertisement
Table of Contents
