Paradyne 3165 Quick Reference page 7

Factory default configuration options are shown in boldface type in the following tables.
Table 1. Port Configuration Options (1 of 2)
Option Factory 1
Port Type: Port Type:
Base Rate: Base Rate:
Net DCLB: Net DCLB:
Port LB: Port LB:
All Ones: All Ones:
Rcv Yellow: Rcv Yellow:
(Received Yellow)
Tx Clock: Tx Clock:
InvertTxC: InvertTxC:
(Invert Tx Clock)
InvertData: InvertData:
Factory 2
E530 E530
V.35 V.35
RS449 RS449
X.21 X.21
Nx64 Nx64
Nx56 Nx56
Disab Disab
V.54 V.54
FT1 FT1
Both Both
Disab Disab
DTLB DTLB
DCLB DCLB
Both Both
Disab Disab
DTR DTR
RTS RTS
Both Both
None None
Halt Halt
Int Int
Ext Ext
Enab Enab
Disab Disab
Enab Enab
Disab Disab
5
Comments/Description
Selects the port type: EIA-530A, Selects the port type: EIA-530A,
V.35, RS449, or X.21.
Enables the port to either Nx56 or Enables the port to either Nx56 or
Nx64 rates.
Network-initiated DCLB, allows ,
DCLB to be controlled by inband DCLB to be controlled by inband
V.54 or FT1 (ANSI) codes. ( )
Port-initiated Loopbacks, allows p ,
Loopbacks to be initiated through Loopbacks to be initiated through
the port by the external DTE. e po by e e e a
All ones sent to network (DTE) T1 All ones sent to network (DTE) T1
when DTR or RTS interrupted.
Data port remains enabled, or is p ,
disabled on receiving Yellow on disabled, on receiving Yellow on
network T1.
Selects whether the transmitted
data clock is internal (TXC) or data clock is internal (TXC) or
external (XTXC).
Selects phase inversion of the Selects phase inversion of the
transmit clock (TXC).
Allows the data on the port to be Allows the data on the port to be
inverted.