7.
Device Configuration
You will need the
Kaiterra Enterprise Configuration Tool
to complete the configuration
process.
When the Kaiterra Square is powered on, the device will enter Configuration Mode for 15
minutes, which will be indicated by a flashing status light on the device. This
configuration mode causes the Kaiterra Square to broadcast a WiFi Access Point signal,
allowing you to connect directly to the device.
Open up the Kaiterra Enterprise
Configuration Tool and connect to the WiFi
signal with "Kaiterra" at the start of its name
SSID .
Once connected, click "Configure" on the Configuration Tool, which will then show your
device's details, including the device's Unique Identifier UDID .
Kaiterra Square Air Quality Monitor Deployment Guide
22