Table of Contents
Advertisement
Cabling
See
Procedure
To cable the 5930 POTS/ISDN splitter:
Figure 6. Typical Installation
Your CPE modems may require in-line filters. Consult your modem documentation.
8
Cables You Need
on page 2 for information about POTS splitter cabling.
1. For each card, connect the DSL interface to the DSL ports connector of your
DSLAM or BLC.
2. For each card, connect the Line interface to the in-building POTS and ADSL
CPE.
3. For each card, connect the PSTN interface to the PBX or PSTN.
4. Secure each cable head with a cable tie and a cable head screw
5. For each chassis, connect the grounding terminal on the back of the chassis to
an earth ground. Use minimum 14 AWG wire.
May 2005
5930-A2-GZ40-00
Advertisement
Table of Contents
