Paradyne 5930 Installation Instructions Manual

Lifeline pots/isdn splitter

Advertisement

Quick Links

5930 Lifeline POTS/ISDN Splitter
Installation Instructions
Document Number 5930-A2-GZ40-00
May 2005
About the 5930 POTS/ISDN Splitters
The 5930 POTS/ISDN splitters separate the DSL (Digital Subscriber Line) and
POTS (plain old telephone service) or ISDN (Integrated Services Digital Network)
frequencies. The 5930 POTS/ISDN Splitter chassis holds from two to eight
POTS/IDSN splitter cards, each of which supports 24 DSL subscriber lines:
The 5930 series shelves provide lifeline POTS: whenever a card is removed from
the shelf, POTS service is uninterrupted, ensuring that critical services like 911
remain available to the end user.
Figure 1. 5930-B1-192 Rear Connectors
5930-A2-GZ40-00
The 1U Model 5930-B1-048 supports 2 cards and 48 DSL subscriber lines
The 3U Model 5930-B1-144 supports 6 cards and 144 DSL subscriber lines
The 4U Model 5930-B1-192 supports 8 cards and 192 DSL subscriber lines
DSL Interface
Line Interface
May 2005
PSTN Interface
1

Advertisement

Table of Contents
loading

Summary of Contents for Paradyne 5930

  • Page 1 The 3U Model 5930-B1-144 supports 6 cards and 144 DSL subscriber lines The 4U Model 5930-B1-192 supports 8 cards and 192 DSL subscriber lines The 5930 series shelves provide lifeline POTS: whenever a card is removed from the shelf, POTS service is uninterrupted, ensuring that critical services like 911 remain available to the end user.
  • Page 2: Product-Related Documents

    Securing the cables Be sure to register your warranty at www.paradyne.com/warranty. Cables You Need Each of the POTS/ISDN splitter card interfaces in the 5930 chassis requires three 50-conductor cables with 50-pin Telco connectors. If every slot is populated and used, you require:...
  • Page 3 The POTS/ISDN splitter chassis is shipped with mounting brackets that allows it to be mounted in a 19″ (483 mm) or 23″ (584 mm) cabinet or rack. Figure 2. 5930-B1-048 Set Up for a 19-Inch Rack 5930-A2-GZ40-00 on page 11.
  • Page 4 Figure 3. 5930-B1-192 Set Up for a 19-Inch Rack In preparation for bracket and chassis installation, determine: Whether the equipment will be rack-mounted. Width of the rack: 19″ (483 mm) or 23″ (584 mm). Whether the rack has mounting rails with threaded or non-threaded screw holes.
  • Page 5 3. Holding the chassis in place, loosely install the bottom screws first and then the top screws. 4. Tighten all screws firmly with a Phillips screwdriver. Repeat the process for each POTS/ISDN splitter chassis. POTS/ISDN splitter chassis can be mounted directly on top of each other. 5930-A2-GZ40-00 May 2005...
  • Page 6 4. Close the locking tabs so they are inside the chassis flanges on either side of the card and the card is fully seated in its connectors. 5. Repeat for all the cards you have to install. Figure 4. Installing a Card in a Model 5930-B1-048 Splitter Chassis May 2005 5930-A2-GZ40-00...
  • Page 7 Figure 5. Installing Cards in Model 5930-B1-144 and 5930-B1-192 Splitter Chassis 5930-A2-GZ40-00 May 2005...
  • Page 8 Cabling Cables You Need Procedure To cable the 5930 POTS/ISDN splitter: 1. For each card, connect the DSL interface to the DSL ports connector of your DSLAM or BLC. 2. For each card, connect the Line interface to the in-building POTS and ADSL CPE.
  • Page 9: Connector Pin Numbers

    Connector Pin Numbers Pin assignments are the same for all connectors on the back of the chassis. 50-Position Telco Connector POTS Splitter # 5930-A2-GZ40-00 Pin # Ring Pin # Tip May 2005 Pin 1 Pin 25 Pin 26 Pin 50...
  • Page 10: Technical Specifications

    Weight 5930-B1-048 5930-B1-144 5930-B1-192 Criteria 5930-B1-000 – 24-Port 900 Ohm Card No DC Blocking 5930-B1-002 – 24-Port 900 Ohm Card No Signature Circuitry No DC Blocking 5930-B1-004 – 24-Port 600 Ohm Card No Signature Circuitry No DC Blocking 5930-B1-006 – 24-Port ADSL/ISDN 159 Ohm...
  • Page 11: Important Safety Instructions

    Directive 72/72/33C – Council Directive of 19 February 1973 on the harmonization of the laws of the member states relating to electrical equipment designed for use within certain voltage limits, as amended by Directive 93/68EEC. 5930-A2-GZ40-00 ) wire for connection to May 2005...
  • Page 12: Warranty, Sales, Service, And Training Information

    Paradyne and the Paradyne logo are registered trademarks of Paradyne Corporation. All other products and services mentioned herein are the trademarks, service marks, registered trademarks, or registered service marks of their respective owners. Copyright 2005 Paradyne Corporation. Printed in U.S.A. *5930-A2-GZ40-00* *5930-A2-GZ40-00* May 2005 5930-A2-GZ40-00...

Table of Contents