Table of Contents
Advertisement
Installing POTS/ISDN Splitter Cards in the Chassis
Procedure
If POTS/ISDN splitter cards are not installed in the chassis:
Figure 4. Installing a Card in a Model 5930-B1-048 Splitter Chassis
6
1. Remove or open the front panel of the splitter chassis by loosening the two
captive screws.
2. Open the plastic locking tabs of a splitter card by pulling them forward.
3. From the front of the chassis, slide the card into a free slot, taking care to keep
the edges of the card in the grooves in the inner walls of the chassis.
4. Close the locking tabs so they are inside the chassis flanges on either side of
the card and the card is fully seated in its connectors.
5. Repeat for all the cards you have to install.
May 2005
5930-A2-GZ40-00
Advertisement
Table of Contents
