Advertisement
~ @REV GUIDE
LEVER ASS'Y
Plastic
molding
bearing
Remove
REV
GUIDE LEVER
ASS'Y
in the direction
of
arrow
@®,pushing
VHJ-0073
slightly
in
the
direction of arrow @.
Be careful not to damage the hook by pushing too
much.
Fig. 7-7-14. Method of Using the jig VHJ-0073
3. Method of Repairing the Bearing Section of
REV GUIDE LEVER ASS'Y
If the
hook
of
the
plastic
molding
bearing
is
damaged
in the process of removing the REV GUIDE
LEVER
ASS'Y, proceed with the repair as follows:
1) Scrape the broken
hook of the bearing section
with
a cutter
knife and
flatten
it.
2)
Insert
the
REV
GUIDE
LEVER
ASS'Y
in the
bearing and fit a stopper washer in. The special
washer to be used must
be Part No. 3-735-755-
01 WASHER (DIA.2.6). This special washer
(part
No. 3-735-755-01
WASHER (DIA.2.6))
is the same
as that used on SUPPLY
REEL ASS'Y or TAKE-
UP REEL
ASS'Y.
Remove
the REV
GUIDE
LEVER
ASS'Y
toward
an
arrow
B while
pushing
the jig VHJ-0073
lightly in
the direction
of an
arrqw.
Pushing the jig VHJ-0073 -too much may cause hook
breakage. Therefore, care
should
be taken.
Flatten the broken
latete) aml are B=
dal hi
2 ag
Special
washer
(3-735-755-01
WASHER
(DIA.2.6))
Fig. 7-7-15. Method
of
Repairing
the Bearing
Section
of the REV
GUIDE
LEVER
ASSEMBLY
— 125 —
Advertisement
