Starting The Upgrade; Upgrade Succeeded; Upgrade Failed - Eaton NetDirector TRIPP LITE Series Owner's Manual

9. Firmware Upgrade Utility

9.2 Starting the Upgrade

To upgrade your firmware:
1. Run the downloaded Firmware Upgrade Utility by double-clicking
the file icon or by opening a command line and entering the full
path to it. The Firmware Upgrade Utility Welcome screen
appears.
2. Read and Agree to the License Agreement (click the I Agree
radio button).
3. Click [Next] to continue. The Firmware Upgrade Utility main
screen appears:
The utility inspects your installation. All the devices capable of
being upgraded by the package are listed in the Device List
panel.
4. As you select devices, a detailed description of each appears in
the Device Description panel.
5. After you have made your selection(s), click [Next] to perform
the upgrade. If you enabled Check Firmware Version, the
utility compares the device's firmware levels with that of the
upgrade files. If it finds that the device's version is higher than
the upgrade version, it brings up a dialog box informing you of
the situation and gives you the option to Continue or Cancel.
If the Check Firmware Version is not enabled, the utility
installs the upgrade files without checking whether they are a
higher level version.
As the upgrade proceeds, status messages will appear in the
Status Messages panel and the progress toward completion is
shown on the Progress bar.

9.3 Upgrade Succeeded

After the upgrade has completed, a screen appears to inform you that
the procedure was successful:
Click Finish to close the Firmware Upgrade Utility.

9.4 Upgrade Failed

If the upgrade failed to complete successfully, a dialog box appears
asking if you want to retry. Click Yes to retry. If you click No, the
Upgrade Failed screen appears:
Click Cancel to close the Firmware Upgrade Utility. See the next
section, Firmware Upgrade Recovery, for how to proceed.
18