Table of Contents
Advertisement
•
USB Mode
Switch
•
•
Source Selection
•
Selecting "On" enables the function. The MHL port(s) and the
DC 5V out port/USB A port (if available) on the projector can
output 5V power when the projector is turned on or in
USB 5V
standby mode.
(Standby)
This function is especially suitable for gaming environment. It
reduces input to output latency and helps create a seamless
experience.
Low Input Lag
Control:When selected, you can use the page up/page
down function via the USB port. Firmware can also be
updated via the USB port for service personnel.
Adaptor: When selected, the USB port can only output
power for Chromecast.
Manual: When switching input signals, you need to press
"SOURCE" on the control panel or remote control, or
the direct source key on the remote control.
Auto: The projector will detect your source
automatically.
Only MHL port(s) will provide power output when
MHL port(s) and USB A port are both plugged.
This function is only available for certain input timings.
After turned on, performing Auto Keystone or
adjusting the following settings will deactivate this
function: Aspect ratio, Keystone, H. Position, V.
Position, Frequency, HDMI Scan Info, Digital Zoom.
When Display Mode is Game Dark or Game Bright, this
function will be automatically turned on.
23
Advertisement
Table of Contents
