Table of Contents
Advertisement
Avoid contact with modules directly, which may cause electric shocks or cuts.
The installation should comply with the laws and regulations specified by the relevant region and country. If
necessary, obtain the required certificates such as building permit.
Module installation shall be carried out by qualified professionals with technical knowledge and familiarity with
the mechanical and electrical requirements of the system. Be aware of the risks of injury, including electric shock,
that may occur during installation.
The modules are applied to the ground, roof, fish pond and other outdoor environments. Proper design of
support structures is the responsibility of the system designer or installer. When applied to roof installation, the
overall fire rating of the final structure needs to be considered, as well as the overall maintenance of the later period.
A roof system can only be installed on a roof that has been assessed by a construction expert with the results of a
formal complete structural analysis.
Comply with safety regulations for all installed components. Such as wires and cables, connectors, charging
controllers, inverters, batteries, etc., only the equipment, connectors, wires and brackets that match the solar power
system can be used. If the photovoltaic system uses energy storage batteries, the configuration of the modules should
follow the advice of the battery manufacturer.
Meaning of crossed –out wheeled dustbin: Do not dispose of electrical appliances
as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection
systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain,
damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to
take back your old appliance for disposals at least free of charge.
Electrical safety
For avoid any form of electrical accidents, please followed the following electrical safety provisions strictly.
Damaged modules pose a risk of electric shock and
fire, should be replaced immediately.
The DC voltage generated by module may exceed
30V, please avoid contact directly.
Ensure that the cable is fixed to the support
bracket for installing modules.
Protect cables with catheters in areas accessible to
animals and children.
Do not manually modify or remove any module or
label.
The installation of the module array must be
carried out in isolation from direct sunlight.
The serial voltage of modules must not exceed the
maximum system voltage.
Do not connect modules with connectors of
different models from different manufacturers.
Do not replace roofing and wall materials with
modules.
Do not connect or disconnect modules when there
is current or external current.
Advertisement
Table of Contents
