Using The Appliance - Rowenta LV8030 Manual

CLEANING – MAINTENANCE – STORAGE – TRANSPORT
• Before cleaning the appliance make sure the appliance is turned
off. Clean the appliance after each use with a dry cloth, replace the
protective cap and store your Skin-Sonic Purifier in its storage case.
• To charge your Skin-Sonic Purifier, position the appliance correctly
in the storage case, make sure that the "battery" symbol on the
appliance is visible and the LED is light up during charging. When the
appliance has finished charging, be sure to disconnect the adapter
from the power. Do not charge or store in a high temperature area.
BEFORT FIRST USE
• You have purchased the Rowenta Skin-Sonic Purifier, designed to
upgrade your daily skincare routine. Thanks to its wave-head and
ultrasonic vibrations, the Skin-Sonic Purifier frees your skin from
impurities (blackhead, dirt, excess oil, dead skin cells, comedones,
skin patches...).
• Thanks to the ultrasonic technology, it deeply cleans your skin,
exfoliates and refines the skin texture. In mode 2 HYDRA it helps
nourish and smooth your skin, for an even and radiant complexion.
• The gentle curvature of the blade is designed like a wave in order to
adapt perfectly to the contour of your face.
• Its ultrasonic vibrations transform water into a mist and makes vibrate
the droplets to loosen impurities from your skin and unclog pores.
• Very hygienic, the wave-head undulates on your face and can
be used on both sides (wave down or flat side) according to the
expected function.
• Before first use, fully charge the battery.
• To begin, please read carefully the following instructions and keep
the leaflet in a safe place.

USING THE APPLIANCE

ON
PRESS X 1
6
3 min.
• Clean your skin:
Apply water on your face. Switch on your appliance select the
mode 1 CLEAN (1press). With the wave-head down, cleanse and
exfoliate your skin for 3 minutes maximum. Don't press too hard,
the ultrasound has the power to unclog impurities from your skin
painlessly. Avoid the eye area.
ON
PRESS X 2
• Hydrate your skin:
Apply your daily cream or serum. Select the mode 2 HYDRA (2nd
press). Hydrate your skin using the flat part of your wave-head: the
ultrasonic vibrations helps your cosmetic to be better absorbed. This
step lasts 2 minutes maximum. Avoid the eye area.
ON
PRESS X 3
• Lift your skin:
Select the mode 3 LIFT (3rd press). Slowly move the appliance and
the flat side wave-head, from your chin up to your ears, following the
contour of your face. And on the chin, from the center to the outside. For
2 minutes maximum. Avoid the eye area.
IN CASE OF ANY ISSUE
• Your appliance shuts down during use:
- Check that the battery charge level is sufficient.
- Check that you do not apply too much pressure to the skin in use.
- For any other reason, return your appliance to a service center.
2 min.
2 min.
7