Table of Contents
Advertisement
CAUTION: When drilling into walls, floors or wherever "live" electrical wires may
be encountered, DO NOT TOUCH THE CHUCK OR ANY FRONT METAL PARTS OF
THE DRILL! Hold the Drill gay by the plastic handle to prevent shock if you drill
into a "'live" wire.
i
TWO-POSITION SIDE HANDLE
This handle is supplied with 1⁄2" drills only. It
screws into the threaded hole on either the
right-hand or left-hand side of the gear case.
CAUTION: Always use the side handle and hold
the drill with both hands when using 12" drills.
OPERATION
DRILLING
1.
2.
9.
10.
Always unplug the Drill when attaching or changing bits or accessories.
Open chuck jaws by turning collar with fingers and insert shank of bit about
34" into chuck. Tighten chuck collar by hand. Place chuck key in each of the
three holes, and tighten in clockwise direction. It's important to tighten chuck
with all three holes. To release bit, turn chuck key counter clockwise in just
one hole, then loosen chuck by hand.
. Use sharp drill bits only. For WOOD,
use twist drill bits, spade bits, power
Hold drill firmly to control the twisting action of the drill.
will help prevent jamming.
DRILLING IN METAL
DRILLING IN WOOD
A
Advertisement
Table of Contents
