Black & Decker HOLGUN 1030-10 Owner's Manual page 7

Wire Wheel Brushes
Use in cleaning and remov-
ing rust, scale, old paint.
No. 39008 4" Fine Brush, crimped;
Made of tempered-steel sis
used with 14" drills to
remove rust and scale ae
metals. Leaves a burnished Max. safe RPM—4,500
surface. No. 39009 4" Coarse Brush, crimped; Max. safe
A. No. 21416 Heavy-duty solid oe es RPM—4,500
No. 21418 Small cleaning brush. grinding wheels, wire wheel
Use in cleaning and remov- baiia i ar Ulesae aes
RPM—5,000.
Use with 14" to 4" Drills
13" x 8⁄2" x 34"
Capacity 44" to y2". No. 66547 454" Rubber
Governs drilling depth.
(|
(3
Backing Pad with plain
B. No. 21417 Side-flare brush for close corner
(Not shown.) | brushes and buffing wheels.
ing rust, scale, old paint.
and Wheel Arbors. "er
Heavy-Duty Tool Box rme No. 39015 3" x 34" x Ad Cotton Buff.
Rubber Backing Pad
No. C 1578 Drill Stop. shank.
RSD Drilling
i i Drilling
| iam. Depth |
Round-Shank Masonry Bits in. (in.)
These bits are carbide-tipped for
top performance and extra-long
life in most masonry-drilling
applications.
CHUCK REMOVAL
For Reversing Drills, start with step 1.
For Non-Reversing Drills, skip steps 1 & 2 and start with step 3.
|
1. Place chuck key in chuck as shown in Figure 4. Using a wooden mallet or simi-