Table of Contents
Advertisement
Advanced Operations
Using Alternate Power Sources
You can choose any of the following power sources for your camcorder: battery pack (p.6), the house
current, and 12/24 V car battery. Choose the appropriate power source depending on where you want
to use your camcorder.
Place
Power source
Accessory to be used
Indoors
House current
AC power adaptor AC-V26(supplied)
Outdoor
Battery pack
Battery pack NP-66 (supplied), NP-98/98D, NP-80/80D,
NP-68, NP-66H, NP-C65, NP-60D
In the car
_i
12
V
or 24 V car battery
DC pack DC P-77
Note on power sources
Disconnecting the power source or removing the battery pack during recording or playback may
damage the inserted tape. If this happens, restore the power supply again immediately.
Using House Current
To use the supplied AC power adaptor:
(D
Lift up the viewfinder.
(2)
Connect the AC power cord to a wall outlet. Connect the bottom of the AC power adaptor to the
battery mounting surface of the camcorder.
(
3
)
Set the selector to VTR (DC OUT).
WARNING
Power cord must only be changed at qualified service shop.
PRECAUTION
The unit is not disconnected from the AC power source as long as it is connected to the wall outlet,
even if the set itself has been turned off.
22
Advertisement
Table of Contents
