Radio Shack TRS-80 Operation Manual page 53

Hide thumbs Also See for TRS-80:

Table of Contents

Insert SOURCE Diskette

<ENTER>

the screen shows:

* *

Backup Complete*

Insert SYSTEM Diskette <ENTER>

then press

ENTER!.

Continue to switch back and forth

between the Network 3 software

diskette

(SOURCE diskette,

notch

covered) and the new diskette

(DESTINATION diskette,

notch

uncovered) as instructed on the

screen.

Do not open the disk drive

door while the red light is on.

the screen shows an error message of any kind, or does not say

Backup

Complete,

then put the Network 3 software diskette back in the drive,

press the Reset

button,

and go back to Step 5.

an error still occurs, get

a new blank diskette or bulk erase the diskette you have been using as

destination diskette. Put the Network 3 software diskette back in the

drive, press the Reset button, and go to Step 5.

Table of Contents

Chapters

Table of Contents