Radio Shack TRS-80 Operation Manual page 52

then remove the original Net work 3 software diskette from Drive 0 and store
it in a safe place. You can now place your backup copy in Drive 0 and
continue using the program.
If, after the drives stop spinning, the screen shows an error message of any
kind, or does not say
Backup Complete,
then press the orange Reset button
and go back to Step 6. If an error still occurs, then get a new blank diskette
or bulk erase the diskette you have been using as destination disk. Then
insert the blank diskette in Drive 1, press the Reset button, and go to Step 6.
II.
Model
III
One-Drive System
34
1.
Tum
on the Host (disk) computer. (The ON/OFF switch is under the right
side of the keyboard.)
2. Place an adhesive tab (provided with new diskettes) over the square notch
in the Network
3
software diskette. If you do not have any tabs, use a
small piece of cellophane tape.
3. Insert the Network 3 software diskette in the disk drive with the covered
notch to the left and the label facing up. Close the disk drive door.
4.
Press the orange Reset button.
5. When the screen shows:
Enter Date (MM/DDNY)?
Enter Time (HH:MM:SS)?
TRSDOS Ready
SOURCE Drive Number?
DESTINATION Drive Number?
SOURCE Disk Master Password?
Insert SOURCE Diskette
<ENTER>
Insert DESTINATION Diskette
<ENTER>
You type:
00 lID
[I]
00
[TI [I] [I]
~
I
ENTER
I
(Example for September 1, 1982)
Press
I
ENTER
I
00 00
~
lKI rnJ
[f]
I
ENTER
I
00
!ENTER!
00
!ENTER!
[f] [Al [I] [I] [Yl] [Q] [ID [ID
I
ENTER
I
Press
I
ENTER
I
After the red light goes off, remove
the Network 3 software diskette and
insert a new, blank diskette with the
uncovered square notch to the left
and the label facing up. Close the
door and press
I
ENTER
I.