Radio Shack TRS-80 Operation Manual page 24

16. Insert the diskette containing the program(s) you want to run at the
Student Stations in Drive 1 (the top drive) of the Host computer, with the
label facing up and the square notch to the left. Close the disk drive door.
At each Student Station:
1 7. a. If you want to run an Assembly language program that is contained on
the diskette in Drive 1 of the Host system, type the filename of the
program and press
I
ENTER
I.
b. If you want to run a BASIC program or to program in BASIC, type
IN]
00
[Al
[ID[]~
!ENTER
L*
The screen will show
"Ready. "
To run a
BASIC program that is contained on the diskette in Drive 1 of the Host
system, type
[BJ [[] [NJ
~
filename
~
I
ENTER
I.
(Substitute the filename
of the desired program for the word filename.)
As the program loads into the Student Station, the two asterisks next to
the words
"STUDENT STATION "
on the Host computer screen are replaced
by the number of the Student Station that is loading.
DO NOT turn off power to any Student Station while disk files are open or while
printing/spooling is occurring. Computers can be turned off only when the Host
computer screen looks like this (with two pairs of asterisks and one pair of zeroes
displayed):
*
If you want to run programs that are stored on Model I diskettes, you can use the
CONVERT instruction to transfer them to a Model III diskette, before running them.
(Refer to the manual that accompanied the program or to the Disk System Owner's
Manual for directions on using CONVERT.)
6