NEC MultiSync P555 User Manual page 16

4. Connect the supplied power cord

WARNINGN:
Please refer to the
AC power cord.


CAUTIONN: Please refer to


NOTEN:
• The monitor should be installed close to an easily accessible power outlet.
•
Please make sure that enough power is supplied to the monitor. Please refer to the "Power Supply" in the
specification (See
"MA491" on page 82
5. Cable information
CAUTIONN:

Use the provided specified cables with this product so as not to interfere with radio and television reception.
For HDMI, USB, RS-232C and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
6. Turn on the power for the monitor and the external equipment
Switch on the monitor power first.
7. Operate the attached external equipment
Select the input source for the attached equipment to show the image signal on screen.


NOTEN: If you have selected anything other than HDMI1 for the input, if the main power is turned off, DDC communication
will not be available.
8. Adjust the sound
Make volume adjustments when required.
9. Adjust the picture settings (see page 91)
If necessary, make adjustments to the backlight, colors, contrast, and image position in the OSD PICTURE menu.
"Important Information"
"CAUTION 1".
"P435" on page 78,
and "MA551" on page
Screw
Clamp
section of this user's manual for proper selection of an
"P495" on page 79, "P555" on page
83).
English−12
80, "MA431" on page 81,