Zenith H2546DT Installation And Operating Manual, Warranty page 14

Remote Key Command Functions
Adjust the screen options while in Computer Mode
Note: The following only applies to those TVs equipped with PCZ Scan Conversion technology
While your Presentation TV is in Rear Computer Mode, the table below
lists the commands used to make adjustments to the screen.
The following remote keys apply ONLY to the NUMBER keypad.
Remote Key
1*
2
3**
4
5
6
7
8
9
0
† Auto Size will adjust the computer image to match the TV Screen.
Use a full-screen computer display with high average brightness for best results.
* The image cannot be zoomed in Freeze Mode.
** Compress mode is not available in REAR COMPUTER SVGA as input. It is available
in REAR COMPUTER NTSC OUT as input source.
†† If Zoom Mode is enabled it will cycle through:
1:1, 2:1, 3:1, 4:1, then back to 1:1 etc.
P A G E 1 4
Normal Mode
Enter Zoom Mode
N/A
Compress On/Off
N/A
Enter Menu Mode
N/A
†Auto Screen Size
N/A
N/A
Freeze/Thaw
Menu Mode
N/A †† Increase Zoom or
N/A
N/A
Menu Adjust Down
Cancel Menu Model
Menu Adjust Up
N/A
Menu Select/Next
N/A
N/A
Zoom Mode
Cancel Zoom Mode
Pan Up
Compress On/Off
Pan Left
Enter Menu Mode
Pan Right
N/A
Pan Down
N/A
Freeze/Thaw
206-3492-A