S-Vhs Vcr/External Amplifier - Zenith H2546DT Installation And Operating Manual, Warranty

Hook Up an S-VHS VCR to your TV
Your Zenith TV may be connected to a Super-VHS VCR through the S-Video Input located on the connec-
tion panel on your TV. Also, you may "daisy chain" up to five TVs to one Super VHS VCR through the spe-
cial S-Video LOOP OUT connection.
Hook up your S-VHS VCR to your Zenith TV according to
1
the diagram below.
2 Remove the back of the remote and put in two AAA bat-
teries.
back of
remote
3
Plug in your TV. Do not plug it into a switched outlet.
Your Zenith TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it on DC
Current.
4
If you wish to "daisy chain" more than one TV to receive
the S-VHS signal, you will need to make the following con-
nections with an S-Video cable, inserting one end of the
cable into the LOOP OUT port with the other end inserted
into a S-Video In port of your second Zenith TV or equiva-
lent input for any other brand of TV.
Audio
Audio Output: Use the Left and Right Audio Out jacks to
connect an external amplifier and speakers. (Refer to the
Audio Menu on page 26 for instructions on how to turn
the TV's internal speakers off and on.)
4
206-3492-A
Audio
P A G E 1 1