Remote Control Programming; Programming The Remote - Zenith H2546DT Installation And Operating Manual, Warranty

Programming the Remote

Program your remote to control a variety of A/ V devices
1
The device you want to program should be ON.
2
On the chart in this manual, find the type of
device you're programming and then find the
brand name. Make a note of the three-number
code—you'll need it soon.
3
Press and hold the PRG key. It's recessed so it
doesn't get pushed accidentally. When the indica-
tor light turns on, you can release the key.
4
Push the key with the name of the device you're
programming (VCR, CABLE, AUX, TV).
5
Using the NUMBER keypad, enter the three-num-
ber code found on the chart in the Reference sec-
tion.
6
Press ENTER to save the code The indicator light
will flash three times and turn off if the code was
accepted.
7
Aim the remote at the device and push the
POWER key. The device should turn off. If not, try
the other codes listed and continue from step
three.
Programming your Zenith remote will allow you to use
one remote to work up to 7 different devices!
Not all devices will work with your Zenith remote con-
trol.
206-3492-O
3
PRG
Indicator Light
VCR
CABLE
SURF
VOLUME
1
5 4
7
0
MENU
RECORD PAUSE
REWIND
POWER
AUX TV
FLASHBK MUTE
CHANNEL
VOLUME
CHANNEL
2 3
5 6
8 9
ENTER
QUIT
TV/VCR
TIMER
SOURCE
PLAY
FFWD
STOP
P A G E 3 7
7
4
6