User Operation Guide PRODUCT DESCRIPTION The matrix allows 4 x USB devices to be shared between 4 x host devices, supporting Plug-and-Play. The USB data transfer rate is up to 5Gbps. The matrix provides advanced features including a web interface module for control and confi guration of the Matrix, along with RS- 232 for seamless control integration.
PANEL DESCRIPTION (REAR) 1. HOST: Connects to USB-B port of Host device 2. DEVICES: Connects to USB-A Devices. 3. IR IN: 3.5mm jack to connect IR Receiver. 4. RS232: 3-pin terminal block to connect a computer to control the matrix by sending RS232 commands.
Page 4
SYSTEM OPERATIONS GUI Control The MAX-USB44/P can be controlled via TCP/IP. The default IP settings are: IP Address:192.168.0.178 Subnet Mask:255.255.255.0 Gateway:192.168.0.1 Please type the IP Address of the control PC in the internet browser, and it will enter the below log-in webpage Username: admin Password: admin Please type the username and the password, and then click LOGIN.
Page 5
SYSTEM OPERATIONS Control Tab Use the 4x4 button grid on the page to set which inputs are directed to which outputs. For example, clicking the button on the Input 1 row and Output 1 column, directs input 1 to output 1. Use the 6 numbered buttons under scene area to save and load layout presets.
Page 6
SYSTEM OPERATIONS RS232 Tab ASCII or HEX command format can be selected. ● Baud Rate: Supports 9600, 19200, 38400, 57600 or 115200. ● Command Ending: NULL, CR, LF or CR+LF can be chosen. ● Command: Type the command in this box to control the third-party device which is ●...
Page 7
SYSTEM OPERATIONS Network Tab Static IP or Dynamic Host Configuration Protocol (DHCP). ● Modify the static IP Address, Subnet Mask, and Gateway ● Access Tab Modify the login password ● Choose the firmware upgrade file and click confirm to upgrade the firmware ●...
Page 8
SYSTEM OPERATIONS GUI Upgrade Please visit at http://192.168.0.178.100 for GUI online upgrade. Type the username and password (the same as the GUI log-in setting, modified password will be available only after rebooting) to login the configuration interface. After that, click Administration in the source menu to get to Upload Firmware as show below: Select the desired update file and press Apply, it will start upgrading then.
Page 9
SYSTEM OPERATIONS Set the parameters (baud rate, data bit, stop bit and parity bit) correctly to ensure reliable RS232 control...
Page 10
= xxx.xxx.x.xxx >SetTelnetPort [param1] Set Telnet Port [param1] param1 = 1~9999 >SetTelnet [param1] Set Telnet Port On Or Off param1 = On, Off >GetIP Get IP <MAX-USB44P >GetStatus >GetStatus <FW Version: V1.0.0 <USB *Specifications are subject to changes without notice.
SPECIFICATION Input: 4 x USB-A Output: 4 x USB-B USB Standard: USB 3.2 Gen 1 Control Port: 1 x IR IN 1 x RS232 (3pin phoenix connector) 1 x RJ45 Power Supply: DC 24V 1.25A Power Consumption: 20.4W Product dimension (mm): 200 x 39 x 153 Product Weight: 840g...