Table of Contents
Advertisement
If you set a programme via
App and it does not match
with the knob position,
text appears alternating with
programme duration.
Press and hold this button for longer time
to provide two other functions:
• hold it down for 3 seconds as long as
a click sounds: the Wi-Fi is turned on
and off.
• hold it down for 10 seconds as long
as a double beep sounds and
appears on the display: to reset the
Network Credentials.
7.7 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This button allows activating the Finish In
option and by means of the Plus (+
increases) and Minus (- decreases)
touch buttons it is possible to choose the
time within which a programme should
terminate. The programme end can be
postponed by one 1 hour every + button
touch until 24 hours maximum. The
'finish in' time can be reduce by means of
the - button until 0.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.8 Start / Pause
Touch the Start / Pause
start, pause the appliance or interrupt a
running programme.
7.9 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The recommended maximum load
decreases on the display.
The indicator
blinks on the display
during steam phase.
This option can affect the
programme duration.
When the programme stops the display
shows a zero
, the indicator
steady on and the indicator
blinking, and the Start / Pause
remains lit. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
An half laundry load helps to
reach better results.
7.10 Extra Rinse
With this option you can add a few rinses
to the selected washing programmes and
optimise the fabric softener distribution
and improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents
and in areas where the water is soft.
ENGLISH
19
button to
is
starts
led
Advertisement
Table of Contents
