Table of Contents
Advertisement
18 INSTALLATION
3
Slide the water supply line back through the
channel, pulling gently from inside the
cabinet to make sure the line is not kinked,
pinched, stressed or crushed.
Connecting Power
The dishwasher should have a dedicated properly
grounded branch circuit to connect the 3 wire
setup which includes the ground wire.
If a 3-prong power supply is used, it should be in
an accessible location adjacent to the dishwasher
within 4 ft. (1.22 m) of the dishwasher side and not
behind the dishwasher.
NOTE
• The best location for the electrical conduit is on
the right side of the back wall. Re-route the
electrical cable before installation if the electrical
conduit pipe is longer than 3" (76 mm) and is
centered on the back wall.
1
Turn off electrical power to the unit at the
circuit breaker.
2
Use a Phillips screwdriver to remove the
screw from the junction box cover and
remove the cover.
3
Use a Phillips screwdriver to remove 2 screws
.
a
4
Remove the junction box from the appliance.
5
Insert a 3/8" strain relief
in the junction box. Tighten the ring nut
secure it in place.
6
Insert the electrical cable through the hole in
the strain relief. Tighten 2 screws to secure
the cable.
through the hole
b
to
c
Advertisement
Table of Contents
