Switching On/Off; To Switch The Tv On; To Switch The Tv Off; First Time Installation - VESTEL 50UB8300 Operating Instructions Manual

Switching On/Off

To Switch the TV On

Connect the power cord to a power source
such as a wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode
either:
• Press the Standby button, Programme +/-
or a numeric button on the remote control.
• Press the centre of the joystick on the TV
in or push it up/down until the TV comes
on from standby.

To Switch the TV Off

Press the Standby button on the remote
control or press the centre of the joystick on
the TV in and hold it down for a few seconds,
the TV will switch into standby mode.
To power down the TV completely, unplug
the power cord from the mains socket.
NOTE: When the TV is switched into
standby mode, the standby LED can blink to
indicate that features such as Standby Search,
Over Air Download or Timer is active. The
LED can also blink when you switch on the
TV from standby mode.

First Time Installation

When turned on for the first time, the
language selection screen is displayed. Select
the desired language and press OK.
On the next screen, set your preferences
using the directional buttons.
NOTE: Depending on the Country selection
you may be asked to set and confirm a PIN at
this point. The selected PIN cannot be 0000.
You have to enter it if you are asked to enter
a PIN for any menu operation later.

About Selecting Broadcast Type

Digital Aerial: If Digital Aerial broadcast
search option is turned on, the TV will search
for digital terrestrial broadcasts after other
initial settings are completed.
Digital Cable: If Digital Cable broadcast
search option is turned on, the TV will search
for digital cable broadcasts after other initial
settings are completed. According to your
other preferences a confirmation message
may be displayed before starting to search.
Select YES and press OK to proceed. To
cancel operation, select NO and press OK.
You can select Network or set values such as
Frequency, Network ID and Search Step.
When finished, press OK button.
D-Smart Option
If desired, you can search and store D-Smart
cable channels. On the Network channel
scan screen set the Network option as
DSmart Auto or DSmart Manual. If
manual option is selected, the other options
can be set as desired. When finished, press
OK button.
NOTE: Searching duration will change
depending on the selected Search Step.
Satellite: If Satellite broadcast search option
is turned on, the TV will search for digital
satellite broadcasts after other initial settings
are completed. Before satellite search is
performed some settings should be made.
Digiturk and D-Smart Options
If desired, you can search and store Digiturk
or D-Smart channels. Before the satellite
search starts, a menu will be displayed
where you can select to install Digiturk
or D-Smart channels. Set the Install Type
as Operator and than set the Satellite
Operator accordingly.
If you select DSmart operator, next menu
item will be Apartment Installation. If you
are using an individual D-Smart account,
you should skip this step by setting as
English - 72 -