Table of Contents
Advertisement
HANDLING THE UNEXPECTED
5. Take the kit out of the case.
6. Place the kit face up, on flat ground
near the flat tire, and away from
traffic. Do not place the kit on its
side.
Injecting Sealant and Air
1. Remove the valve cap from the tire valve stem.
2. Remove the sealant/air hose from the packaging.
3. Attach the sealant/air hose onto the tire valve stem. Screw it until it is
tight.
4. Plug in the compressor to the accessory power socket.
5. Start the engine. Keep the engine running while injecting sealant and air.
6. Turn the selector switch to REPAIR (for U.S. models) or SEALANT/AIR or
PRODUIT ANTIFUITE/AIR (for Canadian models).
7. Press the inflator switch to turn on the compressor
8. Unplug the power plug from the accessory power socket.
9. Unscrew the sealant/air hose from the tire valve stem. Reinstall the
valve cap.
10. Press the pressure relief button until the gauge returns to (0 kPa).
11. Apply the repair notification label to the flat surface of the wheel.
Getting Ready to Replace the Flat Tire
1. Open the trunk floor lid.
120 |
2. Take the tool case out. Take the jack
and wheel nut wrench out of the
tool case.
3. Unscrew the wing bolt, then remove the spacer cone. Then, remove the
spare tire.
4. Place the spare tire (wheel side up)
under the vehicle body, near the tire
that needs to be replaced.
5. Loosen each wheel nut about one
turn using the wheel nut wrench.
Setting Up the Jack
n
1. Place the jack under the jacking
point closest to the tire to be
changed.
HANDLING THE UNEXPECTED
| 121
Advertisement
Table of Contents
