Table of Contents
Advertisement
SAFETY INFORMATION
stop, the retractor locks to restrain your body. The front passenger's and
rear seat belts also have a lockable retractor for use with child seats.
Proper Use of Seat Belts
n
Follow these guidelines for proper use:
• All occupants should sit upright, well back in the seat, and remain in the
position for the duration of the trip. Slouching and leaning reduces the
effectiveness of the belt and can increase the chance of serious injury in
a crash.
• Never place the shoulder part of a lap/shoulder seat belt under your arm
or behind your back. This could cause very serious injuries in a crash.
• Two people should never use the same seat belt. If they do, they could be
very seriously injured in a crash.
• Do not put any accessories on the seat belts. Devices intended to
improve comfort or reposition the shoulder part of a seat belt can reduce
the protective capability and increase the chance of serious injury in a
crash.
• No one should sit in a seat with an inoperative seat belt or one that does
not appear to be working correctly. Using a seat belt that is not working
properly may not protect the occupant in a crash. Have a dealer check
the belt as soon as possible.
Not wearing a seat belt properly increases the chance of a serious injury
or death in a crash, even though your vehicle has airbags.
Be sure you and your passengers always wear seat belts and wear them
properly.
Seat Belt Inspection
n
Regularly check the condition of your seat belts as follows:
• Pull each belt out fully and look for frays, cuts, burns, and wear.
• Check that the latch plates and buckles work smoothly and the belts
retract easily. If a belt does not retract easily, cleaning the belt may
correct the problem. Only use mild soap and warm water. Do not use
bleach or cleaning solvents. Make sure the belt is completely dry before
allowing it to retract.
Any belt that is not in good condition or working properly will not provide
proper protection and should be replaced as soon as possible.
4 |
A belt that has been worn during a crash may not provide the same level of
protection in a subsequent crash. Have your seat belts inspected by a
dealer after any collision.
Not checking or maintaining seat belts can result in serious injury or death
if the seat belts do not work properly when needed.
Check your seat belts regularly and have any problem corrected as soon
as possible.
Fastening a Seat Belt
n
Adjust your seat to the proper position and then follow the steps below:
1. Pull the seat belt out slowly.
2. Insert the latch plate into the
buckle, then tug on the belt to make
sure the buckle is secure. Make
sure that the belt is not twisted or
caught on anything.
3. Position the lap part of the belt as
low as possible across your hips,
then pull up on the shoulder part of
the belt so the lap part fits snugly.
This lets your strong pelvic bones
take the force of a crash and
reduces the chance of internal
inquiries.
4. If necessary, pull up on the belt
again to remove any slack, then
make sure that the belt rests across
the center of your chest and over
your shoulder. This spreads the
forces of a crash over the strongest
bones in your upper body.
SAFETY INFORMATION
| 5
Advertisement
Table of Contents
