Table of Contents
Advertisement
HANDLING THE UNEXPECTED
4. Once the engine has cooled down, inspect the coolant level and check the
cooling system components for leaks. If the coolant level in the reserve tank
is low, add coolant until it reaches the MAX mark. If there is no coolant in
the reserve tank, make sure the radiator is cool, then cover the radiator cap
with a heavy cloth and open the cap. If necessary, add coolant up to the
base of the filler neck, and put the cap back on.
Once the engine has cooled sufficiently, restart it and check the temperature
gauge. If the temperature needle has gone down, resume driving. If it has not
gone down, contact a dealer for repairs.
Steam and spray from an overheated engine can seriously scald you.
Do not open the hood if steam is coming out.
Removing the radiator cap while the engine is hot can cause the coolant to
spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the radiator
cap.
Continuing to drive with the temperature gauge needle at the H mark may
damage the engine.
Emergency Engine Stop
The ENGINE START/STOP button may be used to stop the engine due to an
emergency situation even while driving. If you must stop the engine, choose
one of the following operations:
• Press and hold the ENGINE START/STOP
button for two seconds, or
• Firmly press the ENGINE START/STOP
button three times.
The steering wheel will not lock. However,
because turning off the engine disables the
power assist the engine provides to the
steering and braking systems, it will require
significantly more physical effort and time
to steer and slow the vehicle. Use both feet on the brake pedal to slow down
the vehicle and stop immediately in a safe place. With manual transmission
models you can also downshift the transmission to utilize engine braking.
116 |
Continuously Variable Transmission Models: The power mode is in ACCESSORY
when the engine is stopped. To change the mode to VEHICLE OFF, put the
transmission into P after the vehicle comes to a complete stop.
Canadian Continuously Variable Transmission Models: Then press the ENGINE
START/STOP button twice without depressing the brake pedal.
Manual transmission models: The power mode changes to VEHICLE OFF.
Do not press the button while driving unless it is absolutely necessary for the
engine to be switched off.
Emergency Towing
Call a professional towing service if you need to tow your vehicle.
Flat bed equipment: The operator loads your vehicle on the back of a truck. This
is the best way to transport your vehicle.
Wheel lift equipment: The tow truck uses two pivoting arms that go under the
front tires and lift them off the ground. The rear tires remain on the ground. This
is an acceptable way to tow your vehicle.
Trying to lift or tow your vehicle by the bumpers will cause serious damage. The
bumpers are not designed to support the vehicle's weight.
Improper towing such as towing behind a motorhome or other motor vehicle
can damage the transmission.
Tire Pressure Monitoring System (TPMS)
Instead of directly measuring the pressure in each tire, the TPMS on this
vehicle monitors and compares the rolling radius and rotational characteristics
of each wheel and tire while you are driving to determine if one or more tires
are significantly under-inflated. This will cause the low tire pressure/TPMS
indicator to come on and a message to appear on the driver information
interface.
U.S. models only
If your vehicle's tire pressure becomes significantly low, the TPMS has not
been calibrated, if there is a problem with the TPMS or the compact spare tire
is installed, the indicator blinks for about one minute, and then stays on.
HANDLING THE UNEXPECTED
*1
*1 - If equipped
| 117
Advertisement
Table of Contents
