Filling The Rinse Aid Reservoir - Bertazzoni DW60BIT Instruction Manual

Filling The Rinse Aid Reservoir

1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. Power on the dishwasher by plugging in;
2. Within 60 seconds after step 1, press the Program > button more than 5 seconds,
and then press the Delay+ Button to enter the set model, the rinse aid indication
blinks as 1Hz frequency.
3. Press the Program > button to select the proper set according to your using habits ,
the sets will change in the following sequence: D1->D2->D3->D4->D5->D1,
Dispenser drops more rinse aid in D5 level than in another, the manufactory setting
is D3.
4. Without operation in 5 seconds to exit the set model, the set success.
Selector position
D1
D2
D3
D4
D5
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
Amount of rinse aid (mL)
12
1.2
2.4
3.6
4.8
6.0